Skip to content
New furnace installed in an attic, part of the heating and air conditioning services from Chubby's HVAC in Corona

Services · Corona, CA

Heating and Air Conditioning Services in Corona, CA

Heating and air conditioning services in Corona, Riverside, Eastvale and Fontana. Chubby's HVAC installs, repairs and maintains AC systems and furnaces, and replaces ductwork, attic insulation, attic fans and air filters.

Request Service

You can also text (951) 496-7973.

Heating and Air Conditioning Services From Chubby's HVAC

Chubby's HVAC Home Services provides heating and air conditioning services in Corona, Norco, Eastvale and surrounding areas. We work on central air conditioners, gas furnaces and ductless mini-splits, along with the ductwork and the attic that serve them.

New Cooling and Heating Systems

We replace air conditioners and furnaces in Riverside, Fontana and surrounding areas after a load calculation and a static pressure test. Most installs take one to two days. Entry and mid-range systems usually run $14,000 to $16,000, and high-efficiency systems $18,000 to $22,000, without ductwork.

New air conditioner condenser set level on a pad after a system replacement by Chubby's HVAC near Corona, CA

Repairs When the AC Stops Cooling

We repair air conditioners that blow warm air, will not turn on or run without shutting off, for homes in Corona, Eastvale and surrounding areas. The diagnostic is $88, and we credit it toward the repair when you go ahead.

Inside of an outdoor AC condenser opened for a repair by Chubby's HVAC, serving Corona and Eastvale, CA

Yearly Cooling Maintenance

We maintain air conditioners in Norco, Riverside and surrounding areas with readings taken before and after the visit. We wash the coils, clean the blower, clear the drain lines and replace the filter, then email you the checklist with the invoice.

Heating Repair and the $79 Inspection

We repair gas furnaces in Corona, Fontana and surrounding areas and test for carbon monoxide on every heating visit. The $79 heating maintenance and safety inspection covers the burners, blower, gas pressure, carbon monoxide and duct airflow in about an hour and a half.

Older gas furnace in an attic inspected for heating repair by Chubby's HVAC, serving Corona and Fontana, CA

Ducts and Air Filtration

We test static pressure and replace ductwork with R8 insulated flex duct for homes in Eastvale, Norco and surrounding areas. A new duct system usually runs $3,500 to $5,500. We also install media filter cabinets that catch more dust than a standard filter.

R8 insulated flex ductwork run through an attic during a duct replacement by Chubby's HVAC near Norco, CA

Attic Work That Helps the AC

We blow in attic insulation and install gable attic fans for homes in Riverside, Corona and surrounding areas. Many attics here are below the minimum R-rating and have no assisted ventilation, so the heat in the attic works against the air conditioner all afternoon.

What Every Chubby's HVAC Job Includes

Every job in Corona, Eastvale and surrounding areas follows the same standards, whether it is a repair, a tune-up or a new system.

  • Testing. We test the system before we recommend any work.
  • Plain Answers. We explain what we found and give you the price before the work starts.
  • Documentation. We photograph the work and document any change to the scope with you.
  • Code and Specs. We set up every system to local code and the manufacturer's specifications.
  • Warranty. Parts carry the manufacturer's warranty, and we add a labor warranty.
Gas furnace in an attic ready for the $79 heating tune-up and safety inspection from Chubby's HVAC in Corona

Heating season

Book the $79 Heating Tune-Up

We clean the burners and blower, check and adjust the gas pressure, test for carbon monoxide and check duct airflow. It takes about an hour and a half.

Prices

Posted Prices

$88

Diagnostic Visit

We charge $88 for a diagnostic visit and credit it toward the repair when you go ahead.

$79

Heating Maintenance and Safety Inspection

We clean the burners and blower, check the gas pressure, test for carbon monoxide and check duct airflow.

$14,000 to $16,000

Entry and Mid-Range System

A full system swap in Southern California usually lands in this range, without ductwork.

$18,000 to $22,000

High-Efficiency System

High-efficiency systems with more features usually land in this range, without ductwork.

$3,500 to $5,500

New Duct System

A new duct system usually adds this much to a system replacement.

Every new system and duct price is confirmed in writing after we measure the home.

Chubby's HVAC working on an outdoor air conditioner condenser for a homeowner in the Corona, CA area

Same day, next day or within 48 hours

Schedule Service With Chubby's HVAC

Call or text Chubby's HVAC at (951) 496-7973, or send the request form, and tell us what the system is doing.

FAQ

Heating and Air Conditioning Questions

What heating and air conditioning services do you offer?

We install, repair and maintain central air conditioners, gas furnaces and ductless mini-splits. We also replace ductwork, install media filter cabinets, blow in attic insulation and install gable attic fans for homes in Corona and the Inland Empire.

Do you offer emergency or same-day service?

Yes. We take emergency calls, and most calls are scheduled the same day, the next day or within 48 hours. Call or text (951) 496-7973 and we will give you the first open time.

Why is my AC running constantly and never shutting off?

Usually because the system has not been maintained or was never set to the manufacturer's specifications. Dirty coils, low airflow and the wrong refrigerant charge all keep it running. A diagnostic visit shows which one it is.

Why is my utility bill suddenly so high?

Your system is working overtime. That happens when it has not been maintained or when it is making up for a mechanical problem. A diagnostic finds the cause, and catching it early usually costs less than waiting for a part to fail.

Why are some rooms in my house hot while others are freezing?

Uneven temperatures usually come from imbalanced airflow in the ductwork or poor workmanship on the original install. Checking the static pressure against the manufacturer's specifications is the first step to finding the cause.

How often should I change my filter?

On average every 60 to 90 days. It depends on how much the system runs and whether anyone in the home has allergies. If someone has allergies or the system runs most of the day, change it closer to every 60 days.

Do you install one brand only?

No. We work with two or three brands and are not tied to one. AC Pro is the brand we install most. It is designed and made by Lennox, it is popular across the Southwest, and it keeps prices competitive.

Call now Text us